GASGAS, r.v. 2023
Chain 5/8X1/4'' MX
2 066 Kč
Specially developed for use in motocross No O- or Z-rings > minimum loss of power and good durability
Chain 5/8X1/4'' MX
2 066 KčSpecially developed for use in motocross No O- or Z-rings > minimum loss of power and good durability
BRAKE DISC REAR 220X4,6MM
No fading Outer ring made of stainless high-performance brake steel Minimal wear on brake pads Signi...
BRAKE DISC REAR D=220MM
Minimal wear on brake pads Significantly longer lasting Full version for muddy track conditions
BRAKECALIPER REAR BREMBO 2007
Clear pressure point across the entire temperature range More brake power Higher stiffness with the ...
BRAKE CALIPER FRONT
Clear pressure point across the entire temperature range More brake power Higher stiffness with the ...
BRAKE CALIPER GUARD, CARBON, CMPL.
High stiffness and strength Made of high-quality carbon Optimal protection against stone impact Visu...
RADIATOR PROTECTION LEFT/RIGHT
Suitable for the left and right side Provides maximum protection at the lowest possible weight Optim...
RADIATOR PROTECTION
Provides maximum protection at the lowest possible weight Including adapted radiator protection gril...
RADIATOR COVER L+R
Protects the radiator from mud, dirt and sand Protection against rapid overheating of the engine in ...
AUXILIARY WIRING HARNESS
Enables power consumers such as grip heater or radiator fans to be installed on motocross or cross-c...
Y-DISTRIBUTOR
The Y-distributor allows you to connect two power consumers to auxiliary wiring harness 77711979000.
Y-DISTRIBUTOR
The Y-distributor allows you to connect two power consumers to auxiliary wiring harness 77711979000....
HOURMETER BRACKET TTV
To assemble the hour counter on the triple clamp.
MAP SWITCH
Ignition curve adjustment made easy! Comfortable ignition curve adjustment on the handlebar
FRONT AXLE PULLER
Makes removal of the front wheel easier For all front axles with a diameter of 22 mm.
FACTORY FRONT WHEEL 1.6X21''
Anodised hub milled from a whole piece Maximum weight saving compared to standard wheels Maximum gai...
FACTORY FRONT WHEEL 21
Anodised hub milled from a whole piece Maximum weight saving compared to standard wheels Maximum gai...
FACTORY REAR WHEEL 19
Anodised hub milled from a whole piece Maximum weight saving compared to standard wheels Maximum gai...
FACTORY REAR WHEEL 18''
Anodised hub milled from a whole piece Maximum weight saving compared to standard wheels Maximum gai...
FRONT WHEEL CPL. 3,5X16,5''
comes with bushings for 26mm axle diameter can be adapted to other axle diameter by using the bike's...
REAR WHEEL CPL. 5X17''
comes with bushings for 20mm axle diameter can be adapted to other axle diameter by using the bike's...
FRONT AXLE PULLER CPL
Makes removal of the front wheel easier For all front axles with a diameter of 22 mm.
FORK PUMP
Adjusting the air pressure Convenient and easy to use Very easy operation
SPRING HOOK
Comfortable unhooking of springs Convenient and easy to use Easy handling and operation
GUID. BUSHING DISM./MOUNT.
Tool for pressing in components (DU bush in seal ring retainer)
NITROGEN FILL DEVICE 2005
Tool for filling the damper with nitrogen
CLAMPING BLOCK 4054
Tool for clamping components (outer tube, fork leg)
CLAMP BLOCK PISTON ROD D=18/10
Tool for clamping components (fluid barrier needle)